Clamping mitre joints with bar clamps usually ends up as a frustrating tug-of-war…putting too much pressure on one clamp, causing the joint to slip out of alignment, only to repeat the mistake on the opposing corner. There are specialised clamps out there for the job, but they limit the width of your stock.
Woodpeckers' new Mitre Clamping Tool directs the pressure straight across the mitre joint, pulling the joint together, instead of forcing the 45° mitres to slide against each other. Woodpeckers Mitre Clamping Tools work with any stock width, from tiny cove moulding to the largest picture frame stock
Just clamp a tool to each joining workpiece, then place a third clamp across the joint from tool to tool. The vee sections in the profile ensure that the third clamp applies its pressure directly across the joint.
Clamps not included. This item includes 2 x MCT-75P tools.
Available in 2 sizes.
Note that some images serve as range illustrations and may not reflect the actual models and quantities. For an accurate depiction, see the first image on a white background.