Incra Original Jig and Fence - Kit

The ultimate setup for your Router Table, this kit contains Incra's original incramental Jig, along with the Fence System

The Original Incra Jig

This is where it started, and the qualities and capabilities that made it so valuable in workshops then are still the same today. What makes the jig so simple, is what makes it so reliable as well, there are only two moving parts. These are the locking knob and the one piece upper carriage. The strong, glass reinforced resin body consists of upper and lower halves and provides 200mm of solid fence travel, making this the ideal fence system for any machine, not just a router table. It can be used for bandsaws, drill presses, in fact anywhere that needs a little accuracy.

The patented incremental racks are installed where the halves of the jig meet, with each rack offering hundreds of teeth on a precise spacing. Using this method of adjustment is 5 to 10 times more accurate than working visually by eye. When working with any machine, position the jig mounted to a board to either the centre or cutting edge of the cutter being used. From this reference point, accurate positioning can be achieved quickly and easily.

The Incra Fence

The fence system to suit the Oroginal Incra Jig includes all the hardware needed to produce detailed and unique joints such as inlaid dovetails to more basic joints, used as a stop and fence on a bandsaw or drill press.

The fence is 508mm long and laminated on both surfaces, this gives a non-slip surface for ease of use. The 31mm wide x 25mm high opening will cater for most bits being used. The slots in the laminated fence provide are ideal for positioning stops and holding other jigs. Hardware and instructions are provided for this.