Techniglue 500ml Resin

Techniglue Construction Adhesive: Pack the Gaps, Lock the Joint and Keep Water Out

Ever tightened up a joint and watched a thin glue run straight out the sides, leaving a hollow void right where the bond needed to be strongest? That run-out drains away from the very spot doing the work, and you end up with a weak joint and a sticky clean-up. Techniglue Construction Adhesive changes that. This thick, gel-like epoxy stays exactly where you spread it, packing surface voids and curing at room temperature to a high-strength, waterproof bond.

Trusted from the workshop bench to the building site, it delivers a dependable hold on almost any surface.

Key Features

• Thixotropic gel consistency: The thick, non-sagging formula stays put where you spread it, so it fills surface voids inside the joint and minimises run-out for a cleaner, stronger bond.
• High-strength structural bonds: Cures to a tough, load-bearing joint you can rely on for demanding structural work.
• Waterproof once cured: Shrugs off moisture, making it a smart pick for boat work, outdoor builds and anywhere damp is a factor.
• Cures at room temperature: No heat or special gear needed, so you can bond and build right in your own workshop.
• Bonds almost any surface: Grips timber, metal and more, giving you the versatility to take on a wide range of jobs.
• Pre-filled and ready to use: Comes prepared for straightforward mixing and application, so you spend less time preparing and more time building.

Ideal For

• Woodworkers bonding joints that need a strong, gap-filling hold.
• Commercial joiners after a reliable, waterproof structural adhesive.
• Construction crews anchoring threaded rods and mechanical fastenings.
• Bonding and laminating timber beams in civil construction work.

Specifications

• Type: Thixotropic pre-filled epoxy gel adhesive.
• Bond strength: High-strength structural and waterproof.
• Cure: Cures at room temperature.
• Consistency: Thick gel that fills surface voids and minimises run-out.
• Common uses: Anchoring threaded rods, mechanical fastenings and laminated timber beams.
• Bonds with: Almost any surface, including timber and metal.
• Mix ratio: 2:1, measured and mixed accordingly.
• Please note: Resin only. Hardener purchased separately.

A quick tip: check that you have both the resin and the matching hardener on hand before you start, since the resin is sold on its own. Once you have your two parts ready, measure carefully at the 2:1 ratio, stir thoroughly and scrape the sides and bottom of your pot so every bit is fully blended. Because the gel holds its shape, you can build it up in the joint to pack out any gaps, then bring your surfaces together with firm, even pressure and leave the bond to cure undisturbed.

Ready to lay down a strong, waterproof bond that fills the gaps and stays exactly where you put it? Add Techniglue Construction Adhesive to your cart today and craft with confidence.