Techniglue 4ltr Resin

Techniglue Construction Adhesive: Fill the Gaps and Hold Fast Without the Run-Out

Picture spreading glue on a joint that simply refuses to meet cleanly, then watching a thin adhesive drain away from the very void it should be filling. You are left with a hollow spot, a weak bond and a sticky mess to scrape off later. Techniglue Construction Adhesive solves that problem. This thick, pre-filled epoxy gel stays exactly where you put it, packing surface voids and curing to a high-strength, waterproof bond you can build on.

From the workshop bench to the building site, it gives you a dependable hold on almost any surface.

Key Features

• Thixotropic gel consistency: The thick, non-sagging formula stays put where you spread it, so it fills surface voids inside the joint and minimises run-out for a cleaner, stronger result.
• High-strength structural bonds: Cures to a tough, load-bearing joint you can trust on demanding structural work.
• Waterproof once cured: Shrugs off moisture, making it a smart choice for boat work, outdoor builds and anywhere damp is a concern.
• Cures at room temperature: No heat or special gear required, so you can bond and build right in your own workshop.
• Bonds almost any surface: Grips timber, metal and more, giving you the versatility to tackle a wide range of jobs.
• Pre-filled and ready to use: Comes prepared for straightforward mixing and application, so you spend less time preparing and more time building.

Ideal For

• Woodworkers bonding joints that need a strong, gap-filling hold.
• Commercial joiners after a reliable, waterproof structural adhesive.
• Construction crews anchoring threaded rods and mechanical fastenings.
• Bonding and laminating timber beams in civil construction work.

Specifications

• Type: Thixotropic pre-filled epoxy gel adhesive.
• Bond strength: High-strength structural and waterproof.
• Cure: Cures at room temperature.
• Consistency: Thick gel that fills surface voids and minimises run-out.
• Common uses: Anchoring threaded rods, mechanical fastenings and laminated timber beams.
• Bonds with: Almost any surface, including timber and metal.
• Mix ratio: 2:1, measured and mixed accordingly.

A quick tip: get your surfaces ready before you mix, because once you blend the two parts at 2:1 the clock starts ticking. Measure carefully, stir thoroughly and scrape the sides and bottom of your pot so every bit is combined. Since the gel holds its shape, you can build it up in the joint to pack out any gaps, then bring your parts together with firm, even pressure and leave the bond to cure undisturbed.

Ready to lay down a strong, waterproof bond that fills the gaps and stays exactly where you want it? Add Techniglue Construction Adhesive to your cart today and craft with confidence.