Techniglue 1ltr Resin

Techniglue Construction Adhesive: A Gap-Filling Bond That Holds Fast and Keeps Water Out

Ever glued up a joint that just would not sit flush, watching the adhesive run out the edges and leaving voids where the surfaces refused to meet? A runny glue can drain away from the very spot that needs it most, leaving you with a weak bond and a mess to clean up. Techniglue Construction Adhesive puts a stop to that. This thick, gel-like epoxy stays exactly where you spread it, filling surface voids and holding firm while it cures to a high-strength, waterproof bond.

Trusted on the bench and on the building site, it gives you a reliable hold on almost any surface.

Key Features

• Thixotropic gel consistency: The thick, non-sagging formula stays put where you apply it, filling surface voids within the joint and minimising run-out for a cleaner, stronger bond.
• High-strength structural bonds: Cures to a tough, load-bearing joint you can rely on for demanding structural work.
• Waterproof once cured: Shrugs off moisture, making it a solid choice for outdoor projects, boat work and anywhere damp is a factor.
• Cures at room temperature: No special heat or equipment needed, so you can bond and build in your own workshop.
• Bonds almost any surface: Grips timber, metal and more, giving you the versatility to tackle a wide range of jobs.
• Pre-filled and ready to use: Comes prepared for straightforward mixing and application, so you spend less time preparing and more time building.

Ideal For

• Woodworkers bonding joints that need a strong, gap-filling hold.
• Commercial joiners after a reliable, waterproof structural adhesive.
• Construction crews anchoring threaded rods and mechanical fastenings.
• Bonding and laminating timber beams in civil construction work.

Specifications

• Type: Thixotropic pre-filled epoxy gel adhesive.
• Bond strength: High-strength structural and waterproof.
• Cure: Cures at room temperature.
• Consistency: Thick gel that fills surface voids and minimises run-out.
• Common uses: Anchoring threaded rods, mechanical fastenings and laminated timber beams.
• Bonds with: Almost any surface, including timber and metal.
• Mix ratio: 2:1, measured and mixed accordingly.

A quick tip: measure your two parts carefully at the 2:1 ratio and mix them thoroughly before you apply, scraping the sides and bottom of your pot so every bit is fully blended. Because the gel holds its shape, you can build it up in the joint to fill any gaps without worrying about it running away. Bring your surfaces together with firm, even pressure and let the bond cure undisturbed for the best result.

Ready to lay down a strong, waterproof bond that fills the gaps and stays put? Add Techniglue Construction Adhesive to your cart today and craft with confidence.